• Jacquard Puff Additive is used to increase the relief of prints on paper, fabric and other surfaces.
• Simply mix a little of the additive into your Jacquard Screen Ink (up to 20%), print as usual and then apply heat to your print.
• The microspheres in the Puff Additive expand with heat, giving you a raised print only after heating.
• Once puffed, the print is washfast and dry-cleanable.

FABRIC/FIBER/SURFACES

• Natural or synthetic fabric and paper, vinyl, metal and leather

INSTRUCTIONS

• USE: Add to Jacquard Screen Ink (JSI) up to 20% by weight. Mix thoroughly. Pot life of mixture is indefinite. Apply heat to print and ink will puff in all directions. For use on paper, fabric, and other surfaces.

   

• FINISH: Puff Additive has a matte finish and will affect the semi-gloss finish of JSI in proportion to the amount added.

   

• OPACITY: Puff Additive becomes opaque upon expansion and will opacify JSI in proportion to the amount added.

   

• MESH COUNT: 80-305/inch (32T-122T cm) or according to ink specifications. JSI is recommended with mesh counts 80-160/inch (32T-64T cm).

   

• DRYING / CURING: While print is wet, heat the entire ink deposit to 275˚F/135˚C using a hot air gun or oven to puff. Do not overheat. For best results, allow ink to air cure 72 hours once puffed before washing.

   

• CLEAN UP: Cleans up with water or mild detergent.

   

• CAUTION: Always test this product for washability and durability prior to production.